Will The Vacuum Skin Packaging Machine Cause Noise And Pollution?

The core component of Semi Automatic Tray Sealing Machine is the vacuum pump, so it plays a key role in the use of the vacuum packaging machine. It is also common for the vacuum pump to fail after long-term use, which is mainly reflected in this aspect. How to solve these problems? How should the staff properly adjust the vacuum pump of the vacuum packaging machine to restore it to normal working condition? Let us share the following with you.

The vacuum pump of the vacuum skin packaging machine does not work or has serious noise, which may be caused by the following reasons:

1. The power supply is out of phase or the fuse is open. The solution is to check the incoming line of the power supply or replace the fuse core.

2. The vacuum pump of the vacuum packaging machine is reversed. The solution is to change the phase of the power supply.

3. The main contact of the IC has poor contact. The solution is to adjust or replace it.

4. The normally closed contact of the ISJ is bad. The solution is to adjust or replace it.

5. The vacuum pump of the vacuum packaging machine did not stop because the ISJ did not work. The solution is to repair or replace it.

From the above few small problems we can see that the vacuum pump of the vacuum packaging machine is a transfer equipment, so there will be noise, but it is basically within the parameter control range. Exhaust gas pollution has no problem with the general environment and will not cause pollution. If it is a clean workshop, the exhaust pipe must be connected to the outside or an oil-free vacuum pump must be used. These are very common problems encountered when using a vacuum packaging machine.